fbpx

You decided to change the color of the walls and take care of it yourself. You have chosen the color; you have the necessary equipment, and only have to go to work. Here’s how to paint without leaving traces, following the advice of Longmont painters and some basic rules.

When do we paint?

Not for nothing, renovation works take place when it’s nice outside. It is not recommended to grab the paint when it is things and, very hot or on a rainy day. Here’s why.

At low temperatures, generally stretching the paint on the substrate is difficult, the drying is slow, and the wet film can get dirty. The temperature should not be less than 5 degrees, even after application, as the paint film formation is not done correctly, thus compromising the quality and durability of the work over time.

At the same time, the temperature should not exceed 35 degrees when given with paint. Avoid applying the product on the facades during the day when the surface is exposed directly to the sun so that the paint dries quickly, the film does not have time to show on the substrate, adherence is low, and defects can occur (traces of brush or roller, exfoliations, etc.). Avoid painting on rainy days or with high moisture content (greater than 70%). Go here.

Space and materials

Every time you paint inside, make sure that there is adequate ventilation of the workspace, both for proper drying of the paint and to avoid inhalation of the released vapors. If possible, release the room from any furniture and other things. If this is not possible, move them so that you have plenty of room beside the walls and where you want to paint. Do not overwrap them with plastic or other material to prevent them from splashing. It is also essential to cover the floor with something not to dirty it. Door and window frames, sockets and switches can include the edge that comes in contact with the scotch wall to protect them.

Prepare your material early. It is vital that when you start painting, all the tools (roller, brush, paddle, abrasive paper, paper tape, plastic foil) and the necessary materials (washable paint, mixing paint for washable plaster, repairs, priming, etc.). You can make a list of the essential things and get them in time so that when you start working, you do not have to interrupt it for something.

Preparing the walls

If necessary, the walls are prepared by removing the old painting gap, which is to fall. The holes and cracks in the wall are repaired, and if they are too thick, they are filled with plaster, only then the plaster is applied. In the next step, the abrasive paper is sanded to the areas where the repairs were made; the ductwork walls cleaned out of the repairs with a clean brush, then the application of the primer, which has the role of fixing the paint on the walls, is carried out. The primer was prepared from glue mixed with water in a ratio of 1/10. After the glue is thoroughly mixed with water, apply it directly to the walls to wet them. Then we wait between 30 and 90 minutes for the moisture to enter the walls.

Apply washable paint

Applying the washable paint is done after the primer has dried. The best application of the washable paint is with the roller. Buy paint quality. Otherwise, you risk not covering the walls well and need to lay more layers. Do not dilute it too much with water, just as much as you need to stretch it well with the trap. Put some water, mix well and try on the wall. If it’s too thin, you’ll have to lay more layers, and it will not be resilient in time.

Useful content: https://www.marthastewart.com/1528771/how-paint-perfect-wall

If you prepare the color at home, do not put the whole pigment once in a washable condition. Put a little color, mix and try with a brush on the wall to see if it’s the color you want. Before you begin to paint, mix the color with your washable coat very well. Otherwise, you risk painting on the walls when painting.

Guest Author